Assembly And Set-Up - Razor E-XR Owner's Manual

ASSEMBLY AND SET-UP

Attaching the Handlebars
Tool Required: 5 mm Allen Wrench
1
Loosen the collar clamp. With a
twisting motion, push and twist to
slide the handlebar onto the fork.
Collar Clamp
3
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer
Service contact information is listed at the back of this manual.
2
With the front wheel pointed
straight ahead and the handlebars
square to the front wheel, tighten
both bolts on the clamp as shown
with a 5 mm Allen wrench. Tighten
securely.
1
4
2
4
WARNING: Failure to
properly tighten the collar clamp
may allow the handlebars to
dislodge while riding and may cause
you to lose control and fall. When
correctly tightened, the handlebars
will not rotate out of alignment
with the front wheel under normal
circumstances.
WARNING: Make sure
that the cable and/or wire are
not pinched or damaged when
installing handlebars.