FIBARO FGWPx-102 Operating Manual page 8

8
i
NOTE
Menu is preceded by
two white flashes of
the LED ring 6 seconds
after the B-button is
pressed.
i
NOTE
Resetting the device is
not the recommend-
ed way of removing
the device from the
Z-Wave network. use
reset procedure only
if the primary con-
troller is missing or
inoperable. Certain
device removal can be
achieved by the pro-
cedure of removing
described in "Adding/
removing the device"
on page 6.
OPERATInG ThE DEvICE
Menu allows to perform Z-Wave network actions. In order to use the
menu:
1. Press and hold the B-button.
2. Wait for the device to indicate desired position with a colour:
• GREEN - erase energy consumption memory
• VIOLET - Z-Wave network's range test
• YELLOW - device reset
3. Release the B-button.
4. Click the B-button to confirm selection.
Controlling the Wall Plug with FIBARO Home Center controller:
FIBARO Wall Plug after successful adding is represented in the
home Center interface with a single icon. It allows to turn on and off
the device and displays current active power and cumulative energy
consumption.
Resetting the Wall Plug:
Reset procedure allows to restore the device back to its factory set-
tings, which means all information about the Z-Wave controller and
user configuration will be deleted.
1. Make sure the device is powered.
2. Press and hold the B-button.
3. Wait for the LED ring to glow yellow (4th menu position).
4. Release the B-button.
5. Click the B-button once to confirm selection.
6. After few seconds the device will restart with factory settings,
which is signalled with the red ring colour.