Table of Contents
Advertisement
Control opposite to the Wall Plug:
•
switching the Wall Plug on – switch the devices off
•
switching the Wall Plug off – switch the devices on
Available settings: 0 - control as the Wall Plug
Default setting:
21. DOWN value - „On/Off (Power)" association group (3)
Lower power threshold, used in parameter 23. DOWn value cannot
be higher than a value specified in parameter 22.
Available settings: 0-24900 (0.0-2490.0W, step 0.1W)
Default setting:
22. UP value - „On/Off (Power)" association group (3)
upper power threshold, used in parameter 23. uP value cannot be
lower than a value specified in parameter 21.
Available settings: 100-25000 (10.0-2500.0W, step 0.1W)
Default setting:
23. The response after exceeding defined power values
This parameter defines the way that 3rd association group devices are
controlled. Depends on the actual measured power (as parameters 21
and 22 settings).
Available settings: 1 - turn the associated devices On, once the
Default setting:
1 - control opposite to the Wall Plug
0
Parameter size:
300 (30W)
Parameter size:
500 (50W)
Parameter size:
power drops below DOWn value (parameter 21)
2 - turn the associated devices OFF, once the
power drops below DOWn value (parameter 21)
3 - turn the associated devices On, once the
power rises above uP value (parameter 22)
4 - turn the associated devices OFF, once the
power rises above uP value (parameter 22)
5 - combination of 1 and 4.
Turn the associated devices On, once the pow-
er drops below DOWn value (parameter 21).
Turn the associated devices OFF, once the pow-
er rises above uP value (parameter 22).
6 - combination of 2 and 3.
Turn the associated devices OFF, once the pow-
er drops below DOWn value (parameter 21).
Turn the associated devices On, once the pow-
er rises above uP value (parameter 22).
6
Parameter size:
1 [byte]
2 [bytes]
2 [bytes]
1 [byte]
ADvAnCED PARAMETERS
15
Advertisement
Table of Contents
