Table of Contents
Advertisement
Available settings: 1-32400 (in seconds)
Default setting:
GROUP 40. COLOUR SETTINGS
40. Power load for violet colour
This parameter determines active power value, which when exceeded,
causes the LED ring flash violet. Function is active only when parame-
ter 41 is set to 0 or 1.
Available settings: 1000-30000 (100.0-3000.0W, step 0.1W)
Default setting:
41. LED ring colour when controlled device is on
When set to 1 or 2, LED ring colour will change depending on active
power and parameter 40. Other colours are set permanently and do
not depend on power consumption.
Available settings: 0 - illumination turned off completely
Default setting:
42. LED ring illumination colour when controlled device is off
Available settings: 0 - illumination turned off completely
Default setting:
43. LED ring illumination colour at the Z-Wave network alarm de-
tection
Available settings: 0 - illumination turned off completely
Default setting:
600 (10min) Parameter size:
25000 (2500W) Parameter size:
1 - colour changes continuously depending on
active power
2 - colour changes in steps depending on ac-
tive power
3 - white, 4 - red, 5 - green, 6 - blue, 7 - yellow
8 - cyan, 9 - magenta
1
Parameter size:
1 - LED ring is illuminated with a colour corre-
sponding to the last measured power, before
the controlled device was turned off
3 - white, 4 - red, 5 - green, 6 - blue, 7 - yellow
8 - cyan, 9 - magenta
0
Parameter size:
1 - no change in colour. LED ring colour is de-
termined by settings of parameters 41 or 42
2 - LED ring flashes red/blue/white
3 - white, 4 - red, 5 - green, 6 - blue, 7 - yellow
8 - cyan, 9 - magenta
0
Parameter size:
2 [bytes]
2 [bytes]
1 [byte]
1 [byte]
1 [byte]
ADvAnCED PARAMETERS
17
Advertisement
Table of Contents
