Advertisement
The DOLXFD1000BS/DOLXFD1000BM connected with Fingerprint Reader:
For example:
Connect F2 as the fingerprint reader to the DOLXFD1000BS/DOLXFD1000BM,
it is of two steps to enroll the valid fingerprint.
Step 1: Add the Fingerprint (A) on F2
Step 2: Add the same Fingerprint (A) on the DOLXFD1000BS/DOLXFD1000BM
The DOLXFD1000BS/DOLXFD1000BM connected with Keypad Reader:
The keypad reader can be 4 Bits, 8 Bits (ASCll), or 10 Bits output format.
Choose the below operation according to the PIN output format of your reader.
> Add PIN Users:
To add PIN users, after enter into programming mode on the DOLXFD1000BS/
DOLXFD1000BM, PIN(s) can be input/ added on either the DOLXFD1000BS/
DOLXFD1000BM controller or the external Keypad Reader.
To DOLXFD1000BS/DOLXFD1000BM can work as Stanard Wiegand Reader,
connected to the third party Controller--- 7 3 #
Notes:
The EM version reads EM cards only, while the HID & EM version can be set to
read HID & EM cards, or HID card only, or EM card only. Factory default card type
of the HID & EM version is HID & EM cards, if you want to change the type, please
se the DOLXFD1000BS/DOLXFD1000BM to Stand Alone Mode (7 2 #) and then set
the type. (See page 11 for setting card type.)
Advertisement
