HanleyLED Concorde Cabinet System Installation Manual page 3

RETROFIT INSTALLATION GUIDE
Concorde Cabinet System
This guide is designed to aid in the installation of HanleyLED's Concorde Cabinet System. Skilled trades people that are familiar with
general construction, electrical, and sign installation techniques should do the installation. Licensed electricians should provide all
installation and hook-up of both the primary and secondary input/outputs of the HanleyLED power supply. All installation and hook-
up should be done in accordance with all National and Local codes and permits. In no way is this document intended to construe
warranty or fitness of use of the products described, nor is it intended to provide safety instruction for those installing the product.
THE FIELD INSTALLATION OF THIS RETROFIT SYSTEM INTO A SIGN IS SUBJECT TO THE
CAUTION:
SOURCE. THE POWER MUST REMAIN OFF WHILE INSTALLING THE LED RETROFIT KIT.
Tools Required:
• Wire cutter & strippers
• Measuring tape
• Marking pens
Prepping the Channel Letter or Cabinet
Step 1
Remove existing neon or fluorescent bulbs by having a licensed electrician disconnect and remove the neon transformers or
fluorescent ballasts. Remove existing neon and standoffs or fluorescent lamps. Leave fluorescent sockets in cabinets with leads
disconnected. This should leave an empty channel letter or cabinet.
NOTE: ALL MATERIALS REMOVED MUST BE DISPOSED OF IN ACCORDANCE WITH
Step 2
Using a non- oil based cleaner, clean the back surfaces of the channel letter or cabinet where the LED modules will be mounted.
This is an important step for good adhesion of HanleyLED modules mounting tape.
Step 3
Installer should examine all parts that are not intended to be replaced by the retrofit kit for damage and replace any damaged
parts prior to installation of the retrofit kit. Do not make or alter any open holes in an enclosure of wiring or electrical
components during kit installation. Any existing holes in the letters or cabinet that will not be used in the installation of HanleyLED
modules should be patched to avoid water damage. Openings smaller than ½" diameter may be sealed with the appropriate
amount of rated caulk or sealant. Openings larger than ½" should be patched using an aluminum or zinc coated steel patch with
rivets and sealant.
Step 4
Proceed with the appropriate HanleyLED module installation guide for your specific product.
ACCECPANCE OF LOCAL INSPECTION AUTHORITY.
TURN OFF POWER TO THE SIGN BEFORE INSPECTING OR REMOVING EXISTING LIGHT
• Drill
• Standard hardware and supplies in addition to the HanleyLED modules
installation guides (UL listing may be required on certain items)
APPLICABLE LOCAL, STATE AND FEDERAL LAWS.
Installation Guide | www.hanleyledsolutions.com | 800.542.9941
3