HanleyLED Concorde Cabinet System Installation Manual page 12

BEFORE YOU BEGIN
Determine your light bar mounting method. Are you using pre-existing sockets to mount?
If so, Retrofit Connectors are included. If not, be sure to purchase our Speed Spring Brackets
for fast and secure mounting.
READ THESE INSTRUCTIONS COMPLETELY AND CAREFULLY
Tools required:
Tape Measure
Components:
Concorde Bar II
Watertight End Cap
24v Power Supply
NOTE:
All materials removed
must be disposed of
in accordance with
applicable local, state,
and federal laws.
2
Screwdriver
Concorde Joint
Speed Spring Bracket Set
(Spring and stationary)
Optional
WARNING check polarity: All connections must be WHITE-TO-RED (+) and BLACK-TO-BLACK (-).
Reverse polarity connections may damage the LEDs and will void product warranty.
Caution: Turn off power to sign before inspecting or removing existing light source.
Power must remain off while installing the Concorde Cabinet System.
Electric Drill
Retrofit (RF) Connector
Concorde Cable Connectors
Optional