Basic Setup; Power-On Initial Configuration; Video Output; Network Output - Datavideo PTC-140T Instruction Manual

5. Basic Setup

5.1 Power-On Initial Configuration

Step 1. Please connect the DC 12 V power adapter.
Step 2. The camera will start the initial configuration, the Red indicator light
will be flashing.
Step 3. When the camera returns to the HOME position (middle position for
P/T) and lens zoom-in/zoom-out is finished, the auto-testing is finished. The IR
led will also stop flashing. If the preset 0 is set, camera will rotate to the 0
preset position after initial configuration.

5.2 Video Output



Network Output

Step 1. Please connect the PTC-140T to the PC/Notebook PC by an Ethernet
cable.
Step 2. Please open your web browser and then enter the default IP address of
the camera into the address bar.
Note: The default Static IP address of the PTC-140T is 192.168.5.163
Step 3. The Login page of the web control user interface will pop-up. Please
enter user name and password (the default user name and password is
admin/admin).
Step 4. After entering into the preview window, the preview screen of the
video will be shown.


Video Output through HDBaseT

Step 1. Please connect the HDBaseT interface on the rear panel of the PTC-
140T camera to the HDBaseT port on the front panel of the HDBaseT receiver
box.
Step 2. Please connect a HDMI cable from the HDMI OUT port to the HDMI
port of the external connected monitor.
Step3. After the self-test of the PTC-140T camera is done, the video will be
shown.
20