Using The Illustrated Parts List - Nordson AZO E360 Customer Product Manual

Using the Illustrated Parts List

Item Part
— 0000000
1 000000
2 000000
E 2018 Nordson Corporation
Numbers in the Item column correspond to numbers that identify parts in
illustrations following each parts list. The code NS (not shown) indicates
that a listed part is not illustrated. A dash (—) is used when the part number
applies to all parts in the illustration.
The number in the Part column is the Nordson Corporation part number. A
series of dashes in this column (- - - - - - ) means the part cannot be ordered
separately.
The Description column gives the part name, as well as its dimensions and
other characteristics when appropriate. Indentions show the relationships
between assemblies, subassemblies, and parts.
S
If you order the assembly, items 1 and 2 will be included.
S
If you order item 1, item 2 will be included.
S
If you order item 2, you will receive item 2 only.
The number in the Quantity column is the quantity required per unit,
assembly, or subassembly. The code AR (As Required) is used if the part
number is a bulk item ordered in quantities or if the quantity per assembly
depends on the product version or model.
Letters in the Note column refer to notes at the end of each parts list. Notes
contain important information about usage and ordering. Special attention
should be given to notes.
Description
Assembly
S Subassembly
S S Part
Quantity Note
1
2 A
1
Part 7580607_01
7