JETI model Duplex REX Series User Manual page 27

computer radio control system
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.
O P E R AT I O N I S S U B J E C T TO T H E F O L LO W I N G T W O
CONDITIONS(1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Warning: Changes or modifications to this device not expressly
Warning: Changes or modifications to this device not expressly approved by Esprit
approved by Esprit Model/JETI USA could void the user's authority to
Model/JETI USA could void the user's authority to operate the equipment.
operate the equipment. "This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled environment. This
equipment is in direct contact with the body of the user under normal
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
operating conditions. This transmitter must not be co-located or
protection against harmful interference in a residential installation. This equipment generates,
operating in conjunction with any other antenna or transmitter." uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
Under Industry Canada regulations, this radio transmitter may only
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
operate using an antenna of a type and maximum (or lesser) gain
equipment off and on, the user is encouraged to try to correct the interference by one or more of
approved for the transmitter by Industry Canada. To reduce potential
the following measures:
radio interference to other users, the antenna type and its gain should
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
• Connect the equipment into an outlet on a circuit different from that to which the
not more than that necessary for successful communication.
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
Conformément à la réglementation d'Industrie Canada, le présent
environment. This equipment should be installed and operated with minimum distance 20cm
émetteur radio peut fonctionner avec une antenne d'un type et d'un between the radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter
gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le
type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à
l'établissement d'une communication satisfaisante. This device
complies with the Industry Canada license-exempt RSS standard(s).