Sony DAV-C450 Operating Instructions Manual page 24

COAXIAL
IN
AUDIO
IN
If you connect a digital satellite receiver with the OPTICAL jack
The digital satellite receiver can be connected to the OPTICAL jack instead of the AUDIO IN
L/R jacks of the system.
The system can accept both digital and analog signals. Digital signals have priority over analog
signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.
If you connect a digital satellite receiver without the OPTICAL jack
Connect the digital satellite receiver to the AUDIO IN L/R jacks of the system.
Setup for the system (for Asian and Australian models)
Setup is necessary for the system, depending on the TV monitor to be connected.
The initial setting for Asian models is NTSC but the Australian model is PAL.
If the color system of the TV is PAL*
To set the system to PAL, turn on the system by pressing 1 on the remote while pressing X on
the system. You need to hold X until DAV-C450 appears on the display. To reset to NTSC, turn
off the system and then turn on again using the remote while pressing X on the system.
* If the color system of the TV is NTSC, do the same operation above to set the system to
NTSC.
Connecting the AC Power Cord
Before connecting the AC power cord of this system to a wall outlet, connect the speakers to the
system (see page 18).
Connect the AC power cord of your TV/video components to a wall outlet.
GB
24
I N
OUT I N
L L
AM
R
R
O P T I C A L
D I G I T A L
I N
AUDIO 1 AUDIO 2 MONITOR OUT
FM
FRONT R CENTER
75Ω
REAR R WOOFER
S P E A K E R
OUT OUT
AUDIO AUDIO
OUT OUT
L
R
Digital satellite receiver
VCR
S V I D E O
( DVD ONLY)
Y P / C P
B B R
V I D E O
COMPONENT VIDEO OUT
FRONT L
REAR L
OUT IN
INPUT
VIDEO
IN
L OUTPUT
R
OPTICAL
TV monitor
/ C
R
IN
COMPOMENT
VIDEO IN
P
B
P
R
Equipment with component
video input jacks
Y
/ B - Y
/ R - Y