Registering A New Board - Addi-Data ADDINUM PA 200 Technical Description

PA 200
ADDIDriver Board Manager (only for the boards with ADDIPACK):
Under Edit/ADDIDriver Board Manager you can check or change the current
settings of the board set through the ADDEVICE Manager.
ADDevice Manager starts and displays a list of all resources available for the
virtual board.
Save:
Saves the parameters and registers the board.
Restore:
Reactivates the last saved parameters and registration.
Test registration:
Controls if there is a conflict between the board and other devices.
A message indicates the parameter which has generated the conflict. If there is no
conflict, "OK" is displayed.
Deinstall registration:
Deinstalls the registrations of all board listed in the table.
Print registration:
Prints the registration parameter on your standard printer.
Quit:
Quits the ADDIREG program.

7.1.2 Registering a new board

IMPORTANT!
i
To register a new board, you must have administrator rights.
Only an administrator is allowed to register a new board or change a
registration.
♦ Call up the ADDIREG program.
Fig. 7-1 is displayed on the screen.
♦ Click on "Insert".
♦ Select the wished board.
♦ Click on "OK".
The default address, interrupt, and the other parameters are automatically set in
the lower fields. The parameters are listed in the lower fields.
If the parameters are not automatically set by the BIOS, you can change them.
Click on the wished scroll function(s) and choose a new value.
Activate your selection with a click.
♦ Once the wished configuration is set, click on "Set".
♦ Save the configuration with "Save".
Software
19