Adjusting The Projected Image - BenQ MS524AE User Manual

3. If the projector is activated for the first
time, select your OSD language following
the on-screen instructions.
4. If you are prompted for a password, press
the arrow keys to enter a six digit
password. See
function" on page 31
5. Switch all of the connected equipment on.
6. The projector will start to search for input
signals. The current input signal being
scanned displays in the screen. If the
projector doesn't detect a valid signal, the
message 'No Signal' will continue
displaying until an input signal is found.
You can also press Source on the projector or remote control to select your
desired input signal. See
• If no signal is detected for 3 minutes, the projector automatically enters
ECO BLANK mode.

Adjusting the projected image

Adjusting the projection angle
The projector is equipped with 1 front adjuster foot and 2 rear adjuster feet. These
adjusters change the image height and projection angle. To adjust the projector:
1. Pull the quick-release lever and lift the front
of the projector. Once the image is
positioned where you want it, release the
quick-release lever to lock the foot in
position. You may also screw the front
adjuster foot to change the image height.
2. Screw the rear adjuster feet to fine tune the
horizontal angle.
If the projector is not placed on a flat surface or
the screen and the projector are not
perpendicular to each other, the projected image becomes trapezoidal. To correct
this situation, see
• Do not look into the lens while the lamp is on. The strong light from the
lamp may cause damage to your eyes.
• Be careful when you press the adjuster button as it is close to the
exhaust vent where hot air comes from.
http://www.pureglare.com.au
"Utilizing the password
for details.
"Switching input signal" on page 33
"Magnifying and searching for details" on page 34
for details.
for details.
Operation 27