Honeywell Miller Vi-Go Manual Series User Instruction Manual page 8

Installing the Vi-Go Automatic Cable Sleeve
to Vertical Cable Lifeline
The unique design of the Vi-Go Automatic Cable Sleeve permits one-hand installation
to the lifeline, while an anti-inversion mechanism prevents the cable sleeve from being
installed upside-down on the cable.
Swivel Carabiner
1. While pushing upward on the underside of the
shock absorber with your thumb, press the lock knob with your index finger.
2. With the lock knob pressed, push the slider into the casing.
3. Through the now-open gap in the casing of the cable sleeve, place the cable sleeve
on the cable such that the arrow on the casing points upward.
4. Release the slider and the lock knob.
5. The Vi-Go Automatic Cable Sleeve is now connected to the cable.
6. Check whether the cable sleeve can freely slide vertically on the cable.
7. Check the functioning of the locking and catch mechanism
by moving the latch.
To remove the Vi-Go Automatic Cable Sleeve from the cable:
1. While pushing upward on the shock absorber, press the lock knob.
2. With the lock knob pressed, push the slider into the casing.
3. Through the now-open gap in the casing of the cable sleeve, remove the cable sleeve.
4. Release the slider and the lock knob.
netzerotools.com
U se r In str uc ti on s - E n gl i s h
Integrated
Shock Absorber
netzerotools.com
Latch
7
Lock Knob
Slider