Cable Sleeve Installation And Operation - Honeywell Miller Vi-Go Manual Series User Instruction Manual

3.0 Cable Sleeve Installation
and Operation
• Before installation of the cable sleeve, carefully inspect according to the manufac-
turer's instructions (see 5.0 Inspection and Maintenance). Do not use if there are any
damaged or missing parts.
• Only one person may be secured to a cable sleeve at any given time.
• Use only with Miller approved compatible lifelines/systems.
• Do not use the system if the device does not lock onto the cable lifeline or if any of its
components do not operate properly.
WARNING: Personal fall protection must always be used in a situation where a
fall hazard exists. A back-up fall arrest system is required when transitioning on
and off the system at a height.
3.1 Vi-Go Automatic Pass-
Through Cable Sleeve
• Corrosion-resistant stainless steel construction.
• Quick and easy to install with absolute single-hand operation.
• Integrated mechanism prevents upside-down installation of
the cable sleeve to the cable.
• Hands-free trailing while climbing and descending, and automatically bypasses inter-
mediate Automatic Pass-Through Cable Guides.
• Spring-activated mechanisms always move device back to initial position.
• Dual locking mechanism prevents accidental unlocking of the device from the cable.
• Locks instantly in the event of a fall.
• Built-in shock absorber reduces impact forces on the user in the event of a fall.
• Fall indicator provides for ease of inspection.
• Attaches to 3/8", 8mm or 10mm* diameter steel vertical cable lifelines.
*NOTE: Automatic Pass-Through Cable Guides (VGCG) are not compatible with
10mm diameter cable lifelines. If the Vi-Go Vertical Cable Lifeline System with
Automatic Pass-Through Cable Sleeve is used with 10mm diameter cable, interme-
diate Manual Pass-Through Cable Guides (TRCG) must be used and therefore the
cable sleeve will not automatically bypass intermediate cable guides.
netzerotools.com
Us er Ins truc tion s - En gli s h
6
netzerotools.com