Operation; Dry Vacuuming; Wet Vacuuming - AEG AP218E2-0 Original Instructions Manual

3. Make sure the latches on the battery pack snap into place
and the battery pack is secured to the product before
beginning operation.

OPERATION

DRY VACUUMING

See figure 4-11.
Be sure to read, understand all warnings and instructions
in the manual before use. Do not vacuum in areas with
Flammable gases or vapors include but are not limited to;
alcohol or aerosol sprays. Explosive dusts include but are
not limited to; coal, magnesium, grain or gun powder. To
reduce the risk of health hazards from vapors or dust, do not
vacuum toxic materials.
CAUTION
of hazardous material into the work area will take place if
not installed. Make sure no battery pack is inserted in the
battery ports before assembly.
NOTE:
dust port of the power tool.
1. Verify that no battery pack is inserted in the battery ports.
2. In order to prepare your vacuum for dry vacuuming, verify
that the HEPA filter is securely mounted. With power head
removed and in upside down position, make sure the filter
is pushed in until it stops against the power head and the
filter cap is installed. Turn the locking knob clockwise to
lock the filter cap in place (Fig 5).
3. For improved dust collecting, fit collection bag flange onto
the inlet stub, taking care not to damage the bag (Fig 4).
4. Place the power head back on the tank, and secure it in
place using the latches (Fig 6).
5. Insert the locking end of the hose into the vacuum port and
lock in place. Push the required attachment onto the free
end of the hose or extension (Fig 7).
6. Open the battery port cover and insert a battery pack in
the battery port (Fig 9).
7. Turn the motor on by turning the switch to the 'I' ON
position (Fig 10).
8. Slide the speed selector for the desired vacuuming speed.
9. Once you have completed vacuuming, flip the switch to
the 'O' OFF position and remove all battery packs from the
battery ports (Fig 10).
WARNING
WARNING
replaced prior to performing wet vacuuming operations.
NOTE:

WET VACUUMING

See figure 11.
Be sure to read, understand all warnings and instructions
in the manual before use. Do not vacuum in areas with
Flammable gases or vapors include but are not limited to;
alcohol or aerosol sprays. Explosive dusts include but are
not limited to; coal, magnesium, grain or gun powder. To
reduce the risk of health hazards from vapors or dust, do not
vacuum toxic materials.
1. Verify that no battery pack is inserted in the battery ports.
Verify that the tank is clean and free of dust and dirt.
2. Remove the HEPA filter and dust bag (Fig 16 & reverse of
Fig 4).
3. Rinse out the inside of tank to remove any loose debris.
4. Carefully install the foam sleeve filter over the filter cage
and place the power head back on the tank (Fig 11).
NOTE:
replaced prior to performing wet vacuuming operations.
Wet vacuuming operation instructions
1. Fit the desired nozzle to the vacuum hose.
2. Verify that the switch is in the 'O' OFF position before
inserting the battery pack.
3. Open the battery port cover and insert a battery pack in
the battery port (Fig 9).
4. Turn the motor on by flipping the switch to the 'I' ON
position (Fig 10).
5. After use, empty the tank (Fig 15).
NOTE:
NOTE: When vacuuming large quantities of liquids, do not
immerse the nozzle completely in the liquid. Leave a gap at the
action when the tank reaches its maximum capacity. You will
notice an increase in motor speed.
When this happens, turn off the machine, remove all battery
9
WARNING
WARNING
WARNING
WARNING
9