Safety Instructions For Miter Saw Stands - Bosch T1B Operating And Safety Instructions Manual

2610001768_T1B 8/17/17 8:57 AM Page 3
Important Safety Instructions for Using
instructions listed below and in your miter saw manual
may result in serious personal injury.
Fully assemble and tighten all the fasteners
required for this stand. Also remember to
occasionally check the stand and make sure it is
still tight. A loose stand is unstable and may shift in
use and cause serious injury.
Turn tool switch off and disconnect power before
mounting to the stand. Unintended startup during
assembly can cause injury.
Before operating make sure the entire unit is
placed on a solid, flat, level surface. Serious injury
could occur if tool with stand is unstable and tips.
Never stand on tool or its stand or use as ladder or
scaffolding. Serious injury could occur if the tool is
tipped or the cutting tool is accidentally contacted. Do
not store materials on or near the tool such that it is
necessary to stand on the tool or its stand to reach
them.
Use only Bosch replacement parts. Any others may
create a hazard.
The Miter Saw should be firmly mounted to the stand
per the instruction manual.
After mounting the Miter Saw to the stand, align,
position and balance the Miter Saw per the instruction
manual.
This T1B Miter Saw Stand is designed to be used with the
Other units may be compatible, but have not been verified for use with the T1B System.
Bosch Model Numbers:
GCM12SD, CM12SD, CM12, CM10GD, CM8S, 4212, 4212L, 4310, 4405, 4410, 4410L, 4412, 5412, 5412L,
3912, 3915, 3918, 3924
This Miter Saw Stand
Read all safety warnings and all
instructions. Failure to follow all
following Bosch miter saws:
Before use, verify that all stand parts are free from
damage and/or deformity.
Before use, verify that all parts or components of the
stand are properly installed.
Before use, swing open each of the legs until the
pin clicks, locking the legs in position.
When mounting the Miter Saw to the stand, make sure
that the tool mounting brackets are in the "UNLOCK"
position, so the tool mount will engage with the rails. Be
sure to hold the saw until it is secured to prevent it from
falling off the rails. Mounting bracket locking knobs
should then be tightened.
When removing the Miter Saw from the stand, loosen
the mounting bracket locking knobs until they rotate to
the "UNLOCK" position. Hold the Miter Saw firmly to
prevent the saw from falling off the rails. Carefully
remove the Miter Saw.
Do not modify the stand in any manner or use the
stand for any purpose other than is stated in these
instructions.
Because cut material may cause the stand to become
unbalanced, always be sure the material is supported
properly. Also, if the piece being cut is placed far
beyond the work support, stand legs on the opposite
side may suddenly be lifted up due to weight
imbalance. To prevent this from occurring, hold the
opposite side firmly before cutting.
3