Safety Symbols; Safety Instructions - Bosch GTA50W Operating/Safety Instructions Manual

The definitions below describe the level of severity for each signal word.
Read all instructions. Failure
to follow all instructions listed
below may result in serious personal injury.
Fully assemble and tighten all the fasteners re-
quired for this stand. Periodically check that all
fasteners are attached and adjusted according to
the assembly instructions included in this manu-
al. A loose stand is unstable and may shift in use
and cause serious injury.
Turn tool switch off and disconnect power before
mounting to the stand. Unintended startup during
assembly can cause injury.
1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 2 1609B08221_GTA50W_Table_Saw_Stand_OSI_20230426.indd 2

Safety Symbols

Please read the manual and pay attention to these symbols.
This is the safety alert symbol. It is used to alert you to potential personal injury
hazards. Obey all safety messages that follow this symbol to avoid possible injury
or death.
DANGER indicates a hazardous situation which, if not avoided, will result in death
or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in
death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could result in
minor or moderate injury.

Safety Instructions

SAVE THESE INSTRUCTIONS
Before operating make sure the entire unit is
placed on a solid, flat, level surface. Serious in-
jury could occur if tool is unstable and tips.
Never stand on tool or its stand or use as lad-
der or scaffolding. Serious injury could occur if
the tool is tipped or the cutting tool is accidentally
contacted. Do not store materials on or near the
tool such that it is necessary to stand on the tool
or its stand to reach them.
Use only Bosch replacement parts. Any others
may create a hazard.
-2-
4/26/2023 11:32:11 AM 4/26/2023 11:32:11 AM