Bosch T1B Operating And Safety Instructions Manual page 8

2610001768_T1B 8/17/17 8:57 AM Page 8
ATTACHING SAW TO
SAW MOUNTING BRACKETS
See Figure 6 and 7.
Always position the saw to achieve maximum balance
and stability. All four corners of the saw must be
bolted to the mounting brackets before use.
Your saw should have four holes that line up with
the slots in the saw mounting brackets:
1. Unplug the saw and lock the saw arm in the down
position.
2. Lift one side of the saw and place a saw mounting
bracket underneath, aligning the carriage bolts with
the miter saw mounting holes, as shown in figure 6.
Note: For saws with offset hole configurations,
slide the front bolt left or right to properly align the
tool to the mounting bracket as in Figure 7.
3. Lower the saw down onto the bracket, feeding the
carriage bolts through the mounting holes.
4. Secure in place using a flat washer (4), lock washer
(5), and nut (6).
5. Repeat steps 1 through 4 to install second bracket
to the other side of the saw.
6. After making sure both brackets are parallel to each
other, finger tighten all four nuts to hold in position.
(See page 9 for mounting saw to the stand and final
instructions on tightening nuts to properly secure
saw to mounting brackets.)
Assembly
FIG. 6
6
5
4
8
FIG. 7