Checking Parking Brake (Aa) - Kioti K9 2400 Manual

7
k9 2400
-34

CheCKINg PARKINg BRAKe (AA)

NOTe
•
The vehicle should be stopped
on a slope (up to 10 degrees)
when the parking brake is fully
applied. With cargo loaded.
When driving the vehicle down-
hill without depressing the brake
pedal, there should be no friction
resistance. In order to keep the
parking brake in the best condi-
tion, check the parking brake
with the following procedure.
1. Park the vehicle on level ground
and apply the parking brake firmly.
2. Stop the engine, raise the cargo
bed and support it with the support
rod. (In case the hydraulic dump-
ing kit is installed, raise the cargo
bed before stopping the engine)
UD200(K9 2400)-유럽향-07.indd 34
(1) Parking brake Cable
3. adjust the length of the parking
brake cable. Test the cable accord-
ing to the procedures described
previously and then adjust its
length as necessary.
U24O734a
(1) Disc Pad
4. Measure the thickness of the pads
on the sides of the parking brake
disc If any of the pads are close to
1 mm (0.04 in.), both pads should
be replaced.
5. after replacing the pads, test the
parking brake and adjust the cable
length accordingly.
6. Check if the parking brake disc is
not worn abnormally.
U24O735a
2017-11-13 오전 11:10:47