4: Connecting The Ac Power Cord - Sony STR-DA3000ES Operating Instructions (STRDA3000ES) Operating Instructions Manual

4: Connecting the AC
power cord
Connect the supplied AC power cord to the AC
IN terminal on the receiver, then connect the AC
power cord to a wall outlet.
S2 VIDEO S2 VIDEO
IN OUT
VIDEO VIDEO
AUDIO AUDIO
EO 2 VIDEO 1
A
B
RONT SPEAKERS
* The configuration, shape, and number of AC outlets
vary according to the area code.
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver's AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
GB
18
AC power cord
AC OUTLET *
S2 VIDEO
IN
VIDEO
AUDIO
AC OUTLET
L
SUB
WOOFER
L
AUDIO OUT
AC IN
terminal
fans, or TVs to this outlet. This may cause a
malfunction.
Before using the receiver
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure.
This procedure can also be used to return
settings you have made to their factory defaults.
1
Press ?/1 on the receiver to turn off the
receiver.
2
Hold down ?/1 on the receiver for 5
seconds.
3
While "ENTER to Clear All" appears in the
display, press MEMORY/ENTER on the
receiver.
After "MEMORY CLEARING..." appears in
the display for a while, "MEMORY
CLEARED!" appears.
The following are reset to their factory
settings.
• All settings in the SPEAKER SET UP,
LEVEL, SURR SET UP, EQUALIZER,
CUSTOMIZE, TUNER and CIS (models
of area code U, CA only) menus.
• The sound field memorized for each input
and preset station.
• All preset stations.
• All index names for inputs and preset
stations.
Note
If "2nd zone on" or "3rd zone on" appears in the
display, the initial setup operation cannot be
performed. Turn off the indication by following the
first tip of "Listening to the sound in another zone"
(page 52).
Before using the remote for the
first time (STR-DA5000ES only)
When you use the remote for the first time, be
sure to perform the following procedure. The
remote is optimized for the receiver.
1
Press RM SET UP.