Cleaning Modes; Suction Control - Shark Lift-Away ZU780 Series Owner's Manual

WHOLE-HOME CLEANING
HARD FLOOR
If the light is illuminated, the vacuum is in Carpet
mode. To clean hard floors, press the selector
button to switch to Hard Floor mode. When the
light is NOT illuminated, the vacuum is in Hard
Floor mode, and the brushrolls will spin slower.
NOTE: The brushrolls will not spin unless the wand is reclined.

SUCTION CONTROL

Suction Control Collar offers variable suction
based on your needs. Slide to MIN to reduce
suction and increase maneuverability on carpets.
Slide to MAX to increase suction on bare floors.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please set to Carpet. NOTE: For particularly
stubborn stuck-on dust messes on hard floors, set to Carpet.
s h a r kc l e a n . c o m
SETTINGS
CARPET
For Carpet cleaning, press the button and it will
illuminate in green. The brushrolls will spin faster.
NOTE: The brushrolls will not spin unless the wand is reclined.
BRUSHROLL INDICATOR LIGHT
WHAT DOES THE BRUSHROLL
INDICATOR LIGHT MEAN?
Solid Green: The brushroll and Soft Roller are
spinning and working properly.
Solid Red: There is a jam in the brushroll area. Turn
your vacuum off and remove any blockages in the
nozzle.
Flashing Red: The motorized floor nozzle is
overheating. Turn off your vacuum and wait for it to
cool down. After vacuum has cooled, move surface
selector switch to Carpet setting, then press the
selector button to turn vacuum back on.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushrolls, turn power on, then
place foot on floor nozzle and tilt handle back.
ABOVE-FLOOR—HANDLE
Press the Handle Release Latch to detach the
handle from the wand.
LIFT-AWAY®—HANDLE
Detach wand from pod, then detach the
handle from the wand (see above). Press the
Lift-Away button to detach the pod from the
floor nozzle.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button to detach the
wand from the pod.
LIFT-AWAY®—WAND
Detach wand from pod (see above). Press the
Lift-Away button to detach the pod from the
floor nozzle.
s h a r kc l e a n . c o m