Shark Zero-M Lift-Away ZU700C Quick Start Manual

MAINTENANCE
Zero-M™ Technology
Zero-M Technology™ actively removes hair wrap from your brushroll while you vacuum. If you run
over a hard or sharp object or notice a noise change while vacuuming, check for blockages or
objects caught in the brushroll.
CLEANING THE BRUSHROLL
To open the brushroll garage, slide both release buttons on the floor nozzle away from you, towards the
back of the nozzle, then lift off the lid. Clear away any objects or debris.
To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down on
both sides of lid until it clicks securely into place.
NOTE: If any hair is wrapped around the brushroll, extending cleaning time will allow Zero-M™ technology to remove it for you. If
some fibers remain wrapped around brushroll after continued use, carefully cut debris with scissors and remove from brushroll.
CLEANING THE SOFT ROLLER
To remove the Soft Roller from the nozzle, lift it out by
the pull tab. Tap loose debris off the Soft Roller. Use a
dry towel to wipe the Soft Roller clean, or to remove
any debris caught in the teeth behind the Soft Roller.
To register your product, or for answers to frequently asked questions, visit registeryourshark.com.
©2019 SharkNinja Operating LLC. SHARK, DUOCLEAN, and LIFT-AWAY, are registered
trademarks of SharkNinja Operating LLC. Zero-M is a trademark of SharkNinja Operating LLC.
Hand wash the Soft Roller as needed. Use only
water, and let air-dry completely for at least
24 hours. Reinsert the Soft Roller under the rubber
bumper in the front of the nozzle until it clicks into place.
ZU700C_QSG_E_PLT_Mv2
Please be sure to read the enclosed Shark
Performance Lift-Away
Upright Vacuum
ZU700C
QUICK
START
GUIDE
Use this Quick Start Guide
to learn about your new
vacuum's great features.
®
Owner's Guide prior to using your unit.
®