Table of Contents
Advertisement
4b: Connecting the video components
How to hook up your
components
This section describes how to hook up your
components to this receiver. Before you begin,
see "Component to be connected" below for
the pages which describe how to connect each
component.
Before connecting cords, be sure to disconnect
the AC power cord (mains lead).
After hooking up all your components,
proceed to "5: Connecting the antennas
(aerials)" (page 36).
Component to be connected
TV
With HDMI jack
If you want to connect several
digital components, but cannot
find an unused input
See "Enjoying the sound/images from other
inputs" (page 94).
Notes
• When connecting optical digital cords, insert the
plugs straight in until they click into place.
• Do not bend or tie optical digital cord.
Tip
All the digital audio jacks are compatible with
32 kHz, 44.1 kHz, 48 kHz and 96 kHz sampling
frequencies.
Video input/output jacks to be
connected
The image quality depends on the connecting
jack. See the illustration that follows. Select
the connection according to the jacks on your
components.
Page
Digital
19
26
29
30
Note
Be sure to turn on the receiver when the video and
31
audio signals of a playback component are being
32
output to a TV via the receiver. Unless the power is
32
turned on, neither video nor audio signals will be
transmitted.
Analog
High quality image
GB
25
Advertisement
Table of Contents
