Sony 4-144-907-43(1) Operating Instructions Manual page 109

2
Press V/v repeatedly to select the item,
then press .
Item Explanation
RETRY Performs the Auto Calibration
again.
SAVE EXIT Saves the measurement
results and exits the setting
process.
WARN CHECK Displays a warning
concerning the measurement
results. See "Message list
after Auto Calibration
measurement" (page 49).
PHASE INFO. Displays the phase of each
speaker (in phase/out of
phase). See "When you select
"PHASE INFO."" (page 109).
DIST. INFO. Displays the measurement
result for speaker distance.
LEVEL INFO. Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
3
Select "SAVE EXIT" in step 2.
The measurement results are saved.
4
Press V/v repeatedly to select the Auto
Calibration type, then press
Auto Explanation
Calibration
type
FULL FLAT Makes the measurement of
frequency from each speaker
flat.
ENGINEER Sets the frequency
characteristics to a set that
matches that of the Sony
listening room standard.
FRONT REF Adjusts the characteristics of
all the speakers to match the
characteristics of the front
speaker.
OFF Set the Auto Calibration EQ
to off.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low frequency characteristics.
The measurement results may vary, depending on
the position of the optimizer microphone and
speakers, and the shape of the room. It is
recommended that you follow the measurement
results. However, you can change those settings in
the Speaker settings menu. Save the measurement
results first, then try to change the settings if you
want.
When you select "PHASE INFO."
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a speaker,
then press
confirm/save Auto Calibration when GUI
function is turned off".
Display
window
xxx*: IN
xxx*: OUT
.
xxx* – – –
* xxx represent a speaker channel.
FL
FR
CNT
SL
SR
SB
SBL
SBR
SW
Tip
Depending on the position of the subwoofer, the
measurement results for polarity may vary.
However, there will be no problems even if you
continue to use the receiver with that value.
to return to step 2 in "To
Explanation
The speaker is in phase.
The speaker is out of phase. The
"+" and "–" terminals of the
speaker may be connected the
other way around. However,
depending on the speakers,
"OUT" appears on the display
window even though the speakers
are connected properly. This is
because of the speakers'
specifications. In this case, you
can continue to use the receiver.
No speakers are connected.
Front Left
Front Right
Center
Surround Left
Surround Right
Surround Back
Surround Back Left
Surround Back Right
Subwoofer
GB
109