Table of Contents
Advertisement
1.
window.
Open
Locate and mark
centerline of window.
2. Screw leveling bolt in correct
3/8" threaded hold of support
channel. Depth of window sill will
determine which 3/8" threaded
hole to use.
3. Place support channel over
centerline of window sill with end
against window stool. Mark window
sill through Locating Hole A in
support channel.
4. Move support channel away
from window stool until Mounting
Hole B is over the mark on the
window sill. Secure the support
channel by driving a Type B wood
screw into the window sill through
Mounting Hole B.
5. Adjust leveling bolt so curved
top of support channel is 1/4"
below the top of the window stool.
This downward tilt toward the
outside prevents water from
entering the room.
Caution: Do not drill a hole in the
base pan. Unit is designed to
operate with approximately 1/2" of
water in the base pan.
6. Center the air conditioner in the
window opening with the bottom
bar sitting behind the window stool.
Do not cover side louvers.
(continued)
Type
B
Wood
Screwy
Hole B
Hole A
31a"
e
Threaded
Channel
Bolt
Side
Louvers
Sash Tracks
OUTSIDE
I
Advertisement
Table of Contents
