Advertisement
1,
t {
Clean the area under the drip pans
often. Built-upsoil, especially
grease, may catch fire. To make
cleaning easier, the plug-insurface
units are removable.
m
Jx@m3:
* Place
the
drip pan in Ihe surface
unit cavity foundon top of the
range. Line up the drip pan so the
unit receptaclecan be seen.
@ Put the trim ring into place over
the drip pan. No~e:The drip pan
must be under the trim ring.
@ Insert the terminals of the plug-in
unit through the openingin the drip
pan and into the receptacle.
@ Guide the surface unit into place
so it fits evenly and fits snugly into
drip pan or trim ring.
TOdean:
@ Wipe around the edges of the
surface unit opening in the range
top. Clean the area below the unit.
Rinse ail washed areas with a damp
cloth or sponge.
Caution: Be sure all controls are
turned OFF before attempting to
clean under the cooktopor removing
the Calrod@unit.
Tb
remove:
~ Raise the unit coil opposite the
receptacle. Lift about one inch
abovethe trim ring and pull away
from (I1C receptacle. Caution: Be
sure the coils are cool before
removing a Calrod@unit.
~ Do not attempt to clean plug-in
surface units in an automatic
dishwasher.
@ Do not immerse plug-in surface
units in liquids of any kind.
@ Do not bend the plug-in surface
unit plug terminals.
@ Do not attempt to clean, adjust
or in any way repair the plug-in
receptacle.
= After removing the plug-in
surface unit, remove the trim ring
and (irip pan to clean under unit.
3"'IR
3'iMl.
N@
.
JQ-Jp
St-iri-amw
l..JHit
The Stay Up surface unii is
stationaryand cannot be.removed.
It can be lifted upwardand locked
in that position for cleaningunder
unit: Be certain unit is cool M41wn
lifting coil l.q%
After lifting coil unit, removetrim
ring and drip pan to clean under
unit. Clean pan and trim ring as
recommended on Cleaning Guide
on page 25.
I
[
(continued IIe.rt p age)
1
,-.
,
.— —.- ---
Advertisement
