Advertisement
,,
.:
<
Proper care and cleaning are
importantso your range willgive
you efllcient and satisfactory
service. Followthese directions
carefullyin caring for your rangeto
assuresafeand proper maintenance.
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid-resistant.
However,any acid foods spilled
(such as fruit juices, tomato or
vinegar)should not be permitted
to remain on the finish.
The area under the range can be
reached easily for cleaning by
removingthe bottom drawer. To
remove, pull drawer out all the way,
tilt up the front and remove it. To
replace, insert glides at back of
drawer beyondstop on rang-e glides.
Lift drawer if necessary to insert
easi~y. L et front of drawer down,
then push into close.
T{)
REMOVE
door, open to BROIL
position. or where you feel hinge
catch s~ightly.Grdsp door at sides;
Ii!.tdoor up and away from hinges.
"b REPLACE, grasp door at sides.
~ine up door with hinges anc[pL!sh
door firmly ink}place.
Yourrange is ventedthrough a duct
located under the right rear Cah-od@
unit. Clean the duct often.
O-WI
Lamp
CAUTION: Before replacingyour
oven bulb, disconnect the electrical
power for your range at the main
fuse or circuit breaker panel or pull
plug. Be sure to let the lamp cover
and bulb cool completelybefore
removing or replacing.
I
\
I
To
remove:
@ Remove the 3 slotted screws in
the lamp cover as shown in diagram.
QDetach lamp cover and remove
bulb.
m
repkm:
QPut in a new 40-watt appliance
bulb,
QInstall lamp cover. Replace 3
screws and tighten, making sure
cover fits flush with oven wall.
QReconnect electrical power to
the range.
{-+
tmiimp
Smfw'x
liamp
WHEN CHANGINGA COOKTOP
LAMP, DO NOT TOUCH THE
METAL AT ENDS OF LAMP.
Yourcooktoplight is easily
replacedwith a fluorescenttube
of the same w~ttage.Make sure the
powerto the rangeis disconnected
at main fuse or circuitbreaker
panel or plug.
TOremove:
~ Lift lamp cover.
@ Place fingers on top near each
end of light bulb.
@ Press down and roll top of bulb
gently towardfront until it stops.
@ Removegently from unit making
sure bulb doesn'thit lamp cover in
removing.
TOreplace:
@ Place fingers on top near each
end of light bulb.
@ Press buib gently into slots and
roil top of bulb gently towardback
until it stops.
~ Place lamp cover down.
Advertisement
