6: Preparing The Receiver And The Remote - Sony 3-289-204-41(1) Operating Instructions Manual

6: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Connect the supplied AC power cord (mains
lead) to the AC INLET terminal on the
receiver, then connect the AC power cord
(mains lead) to a wall outlet.
Notes
• Before connecting the AC power cord (mains
lead), make sure that metallic wires of the speaker
cords are not touching each other between the
SPEAKERS terminals.
• Connect the AC power cord (mains lead) firmly.
A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed
to be connected this way. This is not
malfunction.
GB
36
AC INLET terminal
To the wall outlet
AC power cord
(mains lead)
(supplied)
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1,2 2,3 2,3
1
Press POWER to turn off the
receiver.
2
While holding down TONE
MODE and 2CH/A.DIRECT,
press POWER to turn on the
receiver.
3
Release TONE MODE and 2CH/
A.DIRECT after a few seconds.
After "CLEARING" appears on the
display for a while, "CLEARED !"
appears.
All the settings you have changed or
adjusted are reset to the initial settings.