Specifications - Sony 3-289-204-41(1) Operating Instructions Manual

Specifications

Amplifier section
Power Output
Models of area code CEL, CEK, ECE, TW
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz, THD 0.09%):
Reference Power Output at Stereo Mode
(4 ohms 20 Hz – 20 kHz, THD 0.15%):
Reference Power Output (8 ohms 1 kHz, THD
0.7%)
2)
FRONT :
2)
CENTER :
2)
SURROUND :
2)
SUR BACK :
Reference Power Output (4 ohms 1 kHz, THD
0.7%)
2)
FRONT :
2)
CENTER :
2)
SURROUND :
2)
SUR BACK :
1)
Measured under the following conditions:
Area code
CEL, CEK, ECE
TW
2)
Depending on the sound field settings and the
source, there may be no sound output.
Frequency response
PHONO
Analog
Input
PHONO
Analog
GB
122
1)
100 W + 100 W
85 W + 85 W
110 W + 110 W
110 W
110 W + 110 W
110 W + 110 W
100 W + 100 W
100 W
100 W + 100 W
100 W + 100 W
Power requirements
230 V AC, 50 Hz
110 V AC, 60 Hz
RIAA equalization curve
± 0.5 dB
10 Hz – 100 kHz,
± 3 dB (with sound field
and equalizer bypassed)
Sensitivity: 2.5 mV
Impedance: 50 kohms
3)
S/N : 90 dB (A, 20 kHz
4)
LPF)
Sensitivity: 150 mV/
50 kohms
3)
S/N : 100 dB (A, 20 kHz
4)
LPF)
Digital (Coaxial) Impedance: 75 ohms
Digital (Optical) S/N
Output (analog)
AUDIO OUT
SUB WOOFER
Equalizer
Gain levels
3)
INPUT SHORT (with sound field and equalizer
bypassed).
4)
Weighted network, input level.
FM tuner section
Tuning range
Antenna (aerial)
Antenna (aerial) terminals
Intermediate frequency
AM tuner section
Tuning range
Area code Tuning scale
10 kHz step 9 kHz step
CEL, CEK, ECE
–
TW 530 kHz
1,610 kHz
5)
You can change the AM tuning scale to either 9
kHz or 10 kHz. After tuning in any AM station,
turn off the receiver. While holding down
TUNING MODE, press POWER on the receiver.
All preset stations will be erased when you change
the tuning scale. To reset the scale to 10 kHz (or 9
kHz), repeat the procedure.
Antenna (aerial)
Intermediate frequency
3)
S/N : 96 dB
4)
(A, 20 kHz LPF)
3)
: 96 dB
4)
(A, 20 kHz LPF)
Voltage: 150 mV/
1 kohm
Voltage: 2 V/1 kohm
±10 dB, 1 dB step
87.5 – 108.0 MHz
FM wire antenna (aerial)
75 ohms, unbalanced
10.7 MHz
531 kHz
1,602 kHz
– 531 kHz
5)
1,602 kHz
Loop antenna (aerial)
450 kHz
–
–
5)