Advertisement
Cleaning & Care
Before using your ice cube maker, it is strongly recommended to clean it thoroughly.
Unplug the unit before cleaning or performing maintenance.
1.
Take out the accessory parts under top window.
2. Clean the interior with diluted detergent, warm water and a soft cloth. First, pour the
warm water with diluted detergent into the internal water reservoir and the space
below the transparent window and then use the soft cloth to wipe the surface.
3. Use water to rinse the interior parts and drain out the water by unplugging the drain
cap on the bottom.
4. The exterior should be cleaned regularly with a mild detergent solution and warm
water.
5. Dry the interior and exterior with a soft cloth.
6. When the machine is not in use for a long time, open water drain cap to drain water
completely from water reservoir.
Warning: Fill with potable water only.
Note: Gas inside the unit is flammable.
Specifications
Protection type
Climate type
Power
Ice making current
Ice harvest current
Refrigerant
Vesicant
Net Weight
Enclosure
Troubleshooting
Problem
"
"
symbol is ON and
the arrow flashes.
"
"
symbol is ON and
"
"
letter
F
flashes.
I
N /SN/ST/ T
220-240V/50Hz
0.8A
1.0A
R600a/23g
C5H10
9.5kg
Plastic
Possible cause
Water reservoir is low.
There is too much ice.
No ice cube inside.
Ambient temperature
sensor breakdown
Stop the ice cube maker, fill water and
"
press
ON/OFF
the unit.
Remove some ice from the chamber
There may be an obstacle or some dirt
a ecting the internal sensor. Remove
the obstacle and clean the unit.
The unit can still work but suggested to
contact Kogan.com Support or an
electrical technician to replace with a
new sensor.
9
Solution
"
button again to restart
Advertisement
