Advertisement
Installation
Improper use of the grounded plug can result in electrical shock. If the power cord is
damaged, please contact Kogan.com Support.
1.
This unit should be grounded properly for your safety. The power cord of this
appliance is equipped with a grounding plug which mates with standard grounding
wall outlets to minimise the possibility of electric shock.
2. Plug your appliance into an exclusive, properly installed, grounding wall outlet. Do not
damage the grounding means of the plug under any circumstances. Any questions
concerning power and/or grounding should be directed towards a certified electrician.
3. This appliance requires a standard 220-240V, 50Hz, grounded electrical outlet.
Operation
Unpacking Your Ice Cube Maker
1.
Remove the exterior and interior packaging and then check whether all the
accessories are included. If any parts are missing, please contact Kogan.com Support.
2. Remove all the protective tape on the unit. Open the transparent window and take out
the accessory parts inside.
3. Clean the interior (such as water reservoir, ice cube pushing spring etc.) with
lukewarm water and a soft cloth.
4. Locate your ice cube maker on a flat counter table far from direct sunlight and other
sources of heat (i.e. stove, furnace and radiator). Make sure that there is at least 15
centimetres between the back and sides of your ice cube maker and the wall.
5. Allow the refrigerant fluid to settle down for one hour before plugging your ice cube
maker into power.
6. The power plug must be directly accessible.
Warning: Fill with potable water only.
How to Start the Unit
1. Open the left side door, pour potable water into reservoir. Keep water level below the
"
"
maximum
water level mark.
5
Advertisement
