Advertisement
"
"
2. Plug your ice cube maker into the main power outlet, then the
symbol will flash on the
LCD display window.
3. Press the "ON/OFF" button on the control panel to begin the ice making cycle. After this,
the "
" symbol will turn on in LCD display window and the "
" symbol will flash in the
meantime.
The default size of ice-cube is Large. If you want to select the size of the ice cube, just press
the "SELECT" button to switch between Large
and Small
. If you still think the ice cube
size is not fit for you, you can add to each ice-making cycle time by pressing the "SELECT"
button.
When the unit is running, always press the "ON/OFF" button for more than 5 seconds, then
the digit "0" will appear on the display, the standard time of the ice-making process, continue
to press the "SELECT" button and the digit will change from 0 to 1, 2, then return to 0. After 5
seconds, the settings will be saved, and the digit will disappear.
With digit 1 settings, it will add 1 minute to the standard duration of each ice-making cycle
and for digit 2 settings, the added time will be longer. If the unit is unplugged again, it will
return to the digit 0 settings with standard time.
4. The ice making cycle lasts 6 to 12 minutes, depending on the size of the ice cube selection
and the ambient temperature.
5. While the ice cube maker is on, verify the water level periodically. If water pump can't
pump out water, the ice cube maker will stop automatically and the "
" symbol turn on,
indicating that more water is required in the reservoir.
It is recommended to use the "ON/OFF" button to turn off the unit first, then fill water up to
the Maximum level mark before pressing the "ON/OFF" button again to restart the unit.
Allow the refrigerant liquid inside the compressor to settle for at least 3 minutes before
restarting the unit.
When the Ice Full Indicator is On
6. The ice cube maker automatically stops working when there is no room for more ice in the
"
"
unit and the
ice full symbol will be shown on the display.
Harvesting Ice Cubes
7. Put your ice cube container on the drip tray, press the "ICE" button one time on the control
panel (Button B). The "
" symbol will show on the display, then the ice cube pushing
spring will start to rotate pushing ice cubes out of the unit.
Press the "ICE" button again, to stop this.
6
Advertisement
