Advertisement
Visit baby monitor
Changing the radio key
If your Visit system is activated for no reason, there is probably a nearby system that triggers yours. In order to avoid radio
interference, you need to change the radio key on all units. The radio key switches are located under the monitor cover.
Here is how you change the radio key:
1
Carefully remove the table stand and open the front cover on the baby monitor. Move any
radio key switch to the up (on position) to change the radio key.
2
Press and hold the test/function button on the receiver until the green and yellow Visit LEDs
blink alternately. Release the button.
3
Press both test buttons simultaneously on the baby monitor within 30 s to send the new radio key.
4
All Visit LEDs on the receiver blink 5 times to show that the radio key has been changed. It then returns to normal mode.
Note: All Visit units must be set to the same radio key in order to operate as a group.
1
Troubleshooting
If
The LEDs blink in orange every minute
The baby monitor LED lights up in
green but the receiver is not activated
The baby monitor LED doesn't light up
even though the baby is crying
The baby monitor is activated too easily
The baby monitor is activated too early
The baby monitor is activated too late
The receiver is activated for no
apparent reason
2
Try this
Replace the batteries. Only use 1.5 V AA (LR6) lithium or alkaline batteries.
Check the baby monitor batteries and the receiver batteries and connections.
Move the receiver closer to the baby monitor to make sure it's within range.
Check that the units are set to the same radio key, see Changing the radio key.
Move the baby monitor closer to the baby or increase the microphone
sensitivity, see Adjusting the settings.
Note: Always make sure the baby monitor is out of the child's reach.
Never place the baby monitor in the child's crib or playpen.
Reduce the sensitivity or move the baby monitor further away from the crib, see
Adjusting the settings.
Increase the delay. For more information, see Adjusting the settings.
Reduce the delay, see Adjusting the settings.
There is probably another Visit system installed nearby that triggers your
system. Change the radio key on all units, see Changing the radio key.
3
5
On
Off
4
Advertisement
