Advertisement
Visit baby monitor
Adjusting the settings
The buttons for sensitivity and delay are located on the left side of the baby monitor. When you press the button, the
corresponding LED colour shows the current setting. Then press repeatedly to adjust the setting.
If the baby monitor is not activated when the baby cries – increase the sensitivity.
If the baby monitor is activated too easily – reduce the sensitivity.
If the baby monitor is activated too early or too late – adjust the delay.
Sensitivity settings
65 dB
Red
75 dB
Orange
85 dB
Green
Default signal pattern
When the baby monitor is activated by the baby's voice or the contact mat, the following happens:
1
The LED on the baby monitor lights up in green to show that it is signalling the receiver.
2
The Visit LED on the receiver lights up in orange and it starts to sound, flash or vibrate with a certain pace, called signal
pattern. The baby monitor and the contact mat accessory determine the signal pattern. The default is as follows:
Baby monitor
Source
Baby voice
Contact mat
Changing the signal pattern
If you have more than one child, you can set a unique Visit LED pattern for each baby monitor. Just
open the front cover and move any signal switch to the up (on position) and make sure the other
switches are down (off ).
Baby monitor
Switch
Source
Baby monitor 1
Contact mat 1
Baby monitor 2
Contact mat 2
Baby monitor 3
Contact mat 3
Baby monitor 4
Contact mat 4
Delay settings
30 s Red
10 s Orange
1 s
Green
LED
Green, top
Green, bottom
Receiver signal pattern
LED
Sound
Orange light
Baby melody
Green light
1
Receiver signal pattern
LED
Sound
Orange light
Baby melody
Green light
Baby melody
2
orange blinks
Baby melody
2
green blinks
Baby melody
3
orange blinks
Baby melody
3
orange blinks
Baby melody
Orange blinks
Baby melody
Orange blinks
Baby melody
Vibration
Fast
door chime, low
Slow
Vibration
Fast
Fast
Fast
Fast
Fast
Fast
Fast
Fast
Flash
Yes
Yes
On
Off
Flash
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Advertisement
