Bellman & Symfon BE1491 Quick Start Manual page 2

Visit baby monitor
Setting up the baby monitor
1
Remove the battery pull tab to start the unit.
(You can press and hold both test buttons for 3 seconds to turn it on/off.)
2 Place the baby monitor on the bedside table or mount it on the wall using the supplied screw and plug.
The recommended distance is 0.5 – 2 m, always out of reach from the child.
1
Testing the connection
Using the test button
1
Press both test buttons simultaneously on the baby
monitor. The top LED lights up in green to show that a
radio signal is being transmitted.
2
The orange Visit LED on the receiver lights up to show
that the signal was received. In addition, it starts to
sound, flash or vibrate depending on the receiver.
Note: If you have changed the signal pattern, it will react
in accordance with the table on the following spread.
1
Using your voice
1
2
2
2
Stand by the baby monitor and make some noise. The
top LED lights up in green to show that the sound was
detected.
The orange Visit LED on the receiver lights up to show
that the radio signal was received. In addition, it starts to
sound, flash or vibrate depending on the receiver.
Note: If you have changed the signal pattern, it will react
in accordance with the table on the following spread.
1 2