Setting Up The Ir Id - Sony TA TA-MR2ES Installation Manual

Setting up the IR ID

You can set up the IR ID when the IR ID TEST switch is in
the "ON" or "OFF" position.
When the IR ID TEST is "ON"
Select this setting to teach the six IR codes below to any
IR-based controller.
IR TEST buttons Function
POWER ON/OFF To turn on or off the power.
POWER ON To turn on the power.
POWER OFF To turn off the power.
MUTING To mute the sound.
VOL – To turn down the volume.
VOL + To turn up the volume.
1 Make sure that the ATTENUATOR L/R is adjusted to
minimum. For details, refer page 14.
2 Turn on the amplifier.
3 Set the IR ID TEST switch to the "ON" position.
The IN USE indicator flashes.
ON
OFF
1 2 3 4 TEST
IR ID
4 To output the IR code, for example ID1, set the IR
ID 1 switch to the "ON" position and set the rest of
the IR ID switches (IR ID 2, 3 and 4) to the "OFF"
position. To select other IR ID, refer to the table
below.
1
ID1 ON
ID2 OFF
ID3 ON
ID4 OFF
ID5 ON
ID6 OFF
ID7 ON
ID8 OFF
ID9 ON
ID10 OFF
ID11 ON
ID12 OFF
If you set the IR ID other than those listed in the table
above, the IR ID will automatically be set to ID1.
12 US
2 3 4
OFF OFF OFF
ON OFF OFF
ON OFF OFF
OFF ON OFF
OFF ON OFF
ON ON OFF
ON ON OFF
OFF OFF ON
OFF OFF ON
ON OFF ON
ON OFF ON
OFF ON ON
5 Plug the IR emitter to the IR REMOTE IR OUT jack of
the amplifier.
6 Make sure the learning remote has been set to
learning mode and the IR emitter is touching the
learning remote.
POWER POWER POWER VOL VOL
MUTING
ON / OFF ON OFF
IR TEST
ON
OFF IR IN IR OUT IN OUT IN
12V TRIGGER IR IN AUDIO SENSING 1 2 3 4 TEST
AUTO POWER SELECTOR IR ID IR REMOTE 12V TRIGGER AUDIO
IR emitter
L P
. >
Learning remote
m M -
H X x
F
G g
f
O
7 Press the IR TEST button for the code you want to
learn.
For example, if you want to learn power on/off, press
POWER ON/OFF.
The IN USE indicator flashes faster. It takes about 2.5
seconds to complete the learning. During this time, if
you press other buttons, they will not function.
If learning is not completed, repeat steps 6 and 7.
6 Repeat steps 6 to 7 to learn other buttons.
You can then use the remote to operate the amplifier.
Tips
• Make sure that the IR ID TEST switch is set to the "OFF"
position and the IR ID switches is set correctly before using the
remote to operate the amplifier. When the IR ID TEST switch is
set to "OFF", the amplifier will turn on at the previous
operating condition.
• For details on setting the learning remote to learning mode,
refer to the operating instructions supplied with the remote.
L
R
OUT R L
SPEAKERS AC IN