Adapter Plugs; Extension Cords; Grease Filter; Grounding Instructions - Hotpoint RVM225WL Use And Care Manual

This appliance must be grounded.
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This apptiance is equipped with a
power cord having a grounding
wire with a grounding plug. The
plug must be plugged into an outlet L
that is properly instiled and
of the
use
result in a fisk of el~~tic-shock.
feature on your microwave oven is equipped with two
The e~ust hood
up through the falters and is then discharged through the provided venting
to the outside.
The grease
filters should be cleaned at least once a month. Never
operate the microwave without the filters in place. In situations where
flaming might occur on surfaces below hood, filters will stop the entry
of flames into the unit.
To Remove Grease Ftiter
To remove grease
grasp the "finger hold"
on the filter and slide to
the rear. men pull filter
front. The filter will
drop out.
PREFERRED
METHOD
Ensure proper ground
exists before use
-
Consult a audified elecrncian or
service tectician if the grounding
instructions are not completely
understood, or if doubt exists as to
whether the appliance is properly
grounded.
To Clean and Replace Grease Ftiter
To clean grease falter, soak it ad then
in solution of hot water and detergent. Don't use
darken the metal. Light brushing can be used to
remove embedded dirt.
To replace grwe filter, slide the filter in the frame
slot on the back of the opening.
Pull filter upward and to the front to lock into place.
receptacle is encountered, it is
your personal responsibility and
obligation to have it replaced with
a properly grounded 3-prong wdl
receptacle.
Do not under any circumstance
cut or remove the third (ground)
prong from the power cord.
Do not use an adapter plug with
-
this
Do
not use an etiension cord
with this appliance.
I
METAL
FILTER coo~op FILTER
LIGHT
agitate filter
(continued ne~page)
- -
".: .,.,
25