Page 2
FCC INFORMATION FEDERAL COMMUNICATIONS COMMISSION INDUSTRY CANADA RADIO FREQUENCY INTERFERENCE STATEMENTS This equipment generates, uses, and can radiate radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer’s instructions, may cause interference to radio communication.
Page 3
HOOKSWITCH FCC REQUIREMENTS FOR TELEPHONE-LINE EQUIPMENT 1. The Federal Communications Commission (FCC) has established rules which permit this device to be directly connected to the telephone network with standardized jacks. This equipment should not be used on party lines or coin lines. 2.
Page 4
CDC STATEMENT Items (b) and (d) can be found on the unit’s FCC label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any one line should not exceed five (5.0).
Page 5
HOOKSWITCH CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate. The LOAD NUMBER (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading.
Page 6
NOM STATEMENT 7. El aparato eléctrico debe ser montado a la pared o al techo sólo como sea recomendado por el fabricante. 8. Servicio—El usuario no debe intentar dar servicio al equipo eléctrico más allá a lo descrito en las instrucciones de operación.
Page 7
HOOKSWITCH 17. Cuidado debe ser tomado de tal manera que objectos liquidos no sean derramados sobre la cubierta u orificios de ventilación. 18. Servicio por personal calificado deberá ser provisto cuando: A: El cable de poder o el contacto ha sido dañado; u B: Objectos han caído o líquido ha sido derramado dentro del aparato;...
Page 8
TRADEMARKS USED IN THIS MANUAL TRADEMARKS USED IN THIS MANUAL Any trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
CHAPTER 1: Introduction 1. Introduction D. Self-Adhesive Pads E. Lifting Film (extra high) 1.1 Description The Hookswitch is designed to be used with the 2.4-GHz Wireless Remote Unit. 1.2 Components A. Hookswitch Device 1. Lifting Film (standard) 2. Lifting Height Termination Figure 1-1.
HOOKSWITCH HOOKSWITCH 2. Installation and corresponding slots on the stand. Operation 3. Connect the Hookswitch to 2.1 How the Hookswitch Works the base by inserting the cord’s large plug into the 1. When you are away from port marked AUX at the your desk, the Hookswitch is bottom of the base (Figure used to lift your handset...
CHAPTER 2: Installation and Operation the protective film from one side of the self-adhesive pads Disconnection and attach on the bottom of button the Hookswitch device. Remove the protective film from the other side of the pads and attach the Hookswitch device by pressing it firmly to the Figure 2-4.
Page 13
HOOKSWITCH HOOKSWITCH CHAPTER 2. If the Hookswitch is activated and you cannot hear a dial tone, you should increase the lifting height. To do so, press the red button on the remote again to lower the handset to the Figure 2-6. Completing the Setup. cradle.
Page 14
If you have any problems or increase your telephone’s questions regarding the ring tone volume by Hookswitch, please call following the instructions in Black Box Technical Support your telephone’s user guide at 724-746-5500. See the next (Figure 2-10). section. Figure 2-10. Rotating the Microphone Housing.
Before you ship, • the nature and duration of contact Black Box to get a the problem. Return Materials Authorization (RMA) • when the problem occurs. number.
Page 16
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com...