Table of Contents
Advertisement
It is important that the wire rope have the proper tensioning
when it is installed on the drum. When the wire rope is first
installed, you should operate the hoist, with light to moder-
• Wire rope not tight against wedge
• Wedge may be too large
WINCH MODEL
CH150A, C2H150A, CH185A, C2H185A .
CH230A and C2H230A . . . . . . . . . . . . . .
CH175A and C2H175A . . . . . . . . . . . . . .
Correct Installation
Figure 7
Incorrect Installations
Wedge not
fully seated
Figure 9
WIRE ROPE WEDGE PART NUMBERS
24493* for 7/16 thru 5/8 in. (11 - 16 mm); 24494 3/4 thru 1 in. (19 - 25 mm)
24493 for 7/16 thru 5/8 in. (11 - 16 mm); 24494* 3/4 thru 1 in. (19 - 25 mm)
24492* for 7/16 in. thru 7/8 in. (11 - 22 mm)
ate loads, with reeving that let's you place these loads on
the block and the drum with all the rope off the drum except
for the last three wraps.
Drive from
this side
Wedge and wire rope
fully seated in pocket
Wedge pulled too far
through anchor pocket
• "Dead" end of wire rope and/or wedge may
interfere with proper spooling
• Wedge may be too small
WEDGE PART NO.
7
Figure 8
* Standard Anchor
Figure 10
Hide quick links:
Advertisement
Table of Contents
