BRADEN CH SERIES Installation Maintenance And Service Manual page 34

18. Install the motor end plate and then the brake cylinder
nipple, using a good grade of thread sealant.
19. Lubricate the o-ring and install it on the outside of the
brake cylinder. Push it down until it's resting against
the motor end plate.
20. Install the motor adapter with eight (8) special
BRADEN capscrews and lockwashers.
21. Install the tie plates next. Position the plates so that
the curved part is toward the top of the hoist and curv-
ing away from the drum. Install the sixteen (16) cap-
screws and lockwashers (twenty for CH185A and
C2H185A).
22. Install the tee and hydraulic hoses at this time. Use a
good grade of thread sealant, being careful not to get
it in the hydraulic lines, as it could block an orifice in
the brake valve. The long hose should point to the
right as viewed from the motor end.
23. Lubricate and install a new O-ring around the pilot on
the motor.
32