Leitner LH270 Manual
  1. Manuals
  2. Brands
  3. Leitner Manuals
  4. Headsets
  5. LH270
  6. Manual

Leitner LH270 Manual

Hide thumbs Also See for LH270:
Table of Contents

Advertisement

Quick Links

See also: Manual
WHEN THE CALL COUNTS
LH270/275 Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LH270 and is the answer not in the manual?

Questions and answers

Related Manuals for Leitner LH270

Summary of Contents for Leitner LH270

  • Page 1 WHEN THE CALL COUNTS LH270/275 Manual...

  • Page 2: Table Of Contents

    Connecting with a Leitner Handset Lifter ........

  • Page 3: Product Diagrams

    Headset Product Diagrams 1. Incoming volume up/down 2. Mute button Base Station 3. Headset ON/OFF (and Online Indicator) 1. Battery indicator 4. Noise-canceling boom 2. USB/PC Mode button 5. Battery 3. Office Telephone Mode (TEL) button (Note: Proper battery orientation) 4.

  • Page 4: Setup

    Want to see the setup video? Go to headsets.com/LifterSetup Connecting to a telephone with a headset jack Connecting a Leitner Electronic Hookswitch (EHS) Cable (optional) • Using the included connector cord, connect the TEL port on the back of the headset base to the headset port on your desk phone •...

  • Page 5: Connecting To Your Computer's Usb Port

    EHS cable. Otherwise, just hang up the phone manually Replacing the earpad To remove the earpad of your LH270 or LH275 headset, put your thumb underneath the pad Receiving an incoming call in telephone mode and pull up from the bottom. To replace the earpad, match the notches at the top, then click the bottom in place •...

  • Page 6: Making An Outgoing Call In Usb/Pc Mode

    Adjusting the ring volume Making an outgoing call in USB/PC mode When the headset is ringing to indicate an incoming call, you can adjust the ring volume using the volume control buttons located on the headset. Your headset must be turned off in order •...

  • Page 7: Battery Level Indication

    The four LEDs on the top of the headset base (left side) indicate the battery level of your headset battery Your Leitner headset allows a second headset to be temporarily connected to the base for training or conference calls •...

  • Page 8: Overview Of Audio Signals

    3.13 Overview of audio signals 3.15 Permanently register an additional headset Sound Indication • With the original headset out of the base, press and hold the Volume Up button underneath the base for about five seconds to enter registration mode. The TEL light 2 rapid beeps (60 sec repeat) Low battery on the base will begin to flash to indicate you’re in registration mode...

  • Page 9: Health And Safety Instructions

    • If you experience skin irritation after using this product, discontinue use Please read the following safety and operational instructions before using your Leitner LH270 or LH275 headset. Please keep these instructions for your reference. When using this product, these basic safety precautions and warnings should be followed to reduce the risk of fire,...
  • Page 10 Charging warnings To protect your hearing, some hearing experts suggest you: To avoid the risk of electrical shock, explosion, fire or leakage of corrosive or toxic chemicals, • Set the volume control in a low position before putting your headset on your ear and please observe the following charging and battery warnings: use as low volume as possible •...
  • Page 11 WHEN THE CALL COUNTS © Leitner Headsets For live product support: Call 1-800-432-3738 Mon-Fri 6:00am-4:30pm Pacific Time...

This manual is also suitable for:

Lh275

Table of Contents