Settings; Lock - Martin Audio BlacklineX Powered XP12 User Manual

Settings

This is where to configure a number of the BlacklineX Powered options. To change a setting, you will just need to rotate the speaker control
encoder until the configuration you desire to change is illuminated, then push to select it. Choices are as follows:
Screensaver
This allows you to select the behavior of the LCD screen when nothing has been adjusted for 30 seconds. There are three options:
• High - The LCD screen remains at full brightness
• Low - The screen dims
• Off - The screen turns off. It will turn back on immediately when the encoder is adjusted or pressed
Home Screen
This allows you to select either the mixer screen or the settings menu as the default to which the LCD window will return following 30
seconds of inactivity. The mixer screen is the default.
Auto Con
Allows a previously paired Bluetooth device to auto reconnect if both the device and speaker are powered on and in range. When illuminated,
push the speaker control encoder to select between on or off.
Auto Link BT
Allows two previously paired loudspeakers to automatically re-link if both are powered on and in range. When illuminated, push the speaker
control encoder to select between on or off.
About
This screen displays details including the device, DSP and Bluetooth firmware versions and the unique device ID.
Restore
Restores all parameters back to their default. This is a permanent reset with no undo, so a confirmation dialog helps prevent accidentally
restoring defaults and losing any custom settings.
Illuminating and selecting the left-facing arrow at the bottom of the screen returns you to the previous screen.

Lock

This is where to lock and unlock the interface with a 4-digit numeric password. Push the speaker control encoder to enter lock mode. From
here, rotate the speaker control encoder until the first number you desire is illuminated and press to select. Follow the same procedure for
the next three numbers. Once four numbers have been selected LOCK will be highlighted.
You can select Del which will delete the last entered number, or LOCK which will lock the DSP. No further changes may be made to any
parameters. Rotating the encoder will have no effect, clicking the encoder switch will take you directly to the lock screen where entering
the correct 4 digits will give you the option to unlock the speaker.
Emergency Unlock
If you set up a 4-digit lock code and forget the passcode, please contact your vendor for support.
BLACKLINEX POWERED USER GUIDE V1.0
Copyright © 2019 Martin Audio Ltd.
BLACKLINEX POWERED USER GUIDE
20