AEG IPE64571FB User Manual page 15

14 www.aeg.com
When you switch between
the modes the heat setting
is set back to 0.
Diameter and position of the
cookware
Choose the mode applicable to the size
and the shape of the cookware. The
cookware should cover the selected area
as much as possible. Place the cookware
centrally on the selected area!
Place the cookware with the bottom
diameter smaller than 160 mm centrally
on a single section.
Place the cookware with the bottom
diameter larger then 160 mm centrally
between two sections.
7.2 FlexiBridge Standard
mode
This mode is active when you activate
the hob. It connects the sections into two
separate cooking zones. The sides of the
100-160mm
> 160 mm
zones which operate together in this
mode light up, and they are linked with
shorter illuminated lines. You can set the
heat setting for each zone separately.
Use two left side control bars.
Correct cookware position:
Incorrect cookware position:
7.3 FlexiBridge Big Bridge
mode
To activate the mode touch
see the correct mode indicator
mode connects three rear sections into
one cooking zone. The front section is
not connected and operates as a
separate cooking zone. You can set the
heat setting for each zone separately.
until you
. This