Filling The Reservoir (Automatically) - Baumatic BEC2.1SS Instruction Manual

Filling the reservoir (automatically)

IMPORTANT: Make sure that your appliance has been
connected to your mains water supply (see "Connecting the
coffee machine to the mains water supply" section on page
30 of this booklet).
o Push the water reservoir door (3) on the right hand side to open
it.
o Remove the water reservoir (2) from the cabinet.
o Connect the water softener (20) to the tube that hangs down
inside the water reservoir compartment. IMPORTANT: You must
connect the water softener to the left hand tube.
o Switch the appliance on using the ON/OFF switch (12), the
ON/OFF neon (24) will light.
o The red water reservoir empty neon (28) will flash to indicate
that the water reservoir has no water in it.
o After a few seconds the water reservoir will start to fill with
water.
o If the water reservoir empty neon (28) is still flashing after the
appliance has stopped filling with water, you should switch the
machine off using the ON/OFF switch (12). Then switch the
machine back on to commence a further fill of the water
reservoir.
o When the water reservoir has filled sufficiently, the water
reservoir empty neon (28) will go out.
12