MB QUART STAGE 2 MBQ-STG2-BT Installation Manual page 16

NOTE - The Dual Amplifier Harness is designed and laid out to perfectly connect
power and speaker connections on the driver's side of the amplifiers while the
RCA audio connections are on the passenger side of the RZR.
Make sure your amplifiers are mounted in the position shown in FIG 7-1. This
configuration is critical to make sure you can access your fine tune adjustments
for crossover and bass boost.
STEP 2 - On the front edge you will secure the plate with the 10mm bolt which secures the
down strap that holds the back of the dash pocket shown in FIG 7-3.
DUAL AMP PLATE
For additional technical information, go to the "SUPPORT" tab at MBQUART.com
There you will find helpful, FAQ, TEQ Tips and you can contact Technical Support via email.
NOTICE THE GAP
(FIG 7-2)
(FIG 7-3)
©2018 Maxxsonics USA
16
10mm BOLT
DOWN STRAP