Troubleshooting; Malfunction Causes And Remedies; Storage/Disposal; Storage - Tronic TLG 1000 C5 Operating Instructions Manual

Troubleshooting

In this section you will receive important information for the localisation and
remedying of malfunctions.

Malfunction causes and remedies

The following table will help with localising and remedying minor malfunctions:
Defect
The battery
charger is not
functioning.
The inserted
batteries are not
being charged.
notICE
► If you cannot solve the problem with the aforementioned methods, please
contact Customer Services.

Storage/Disposal

Storage

If you do not intend to use the device for a longer time, remove the batteries and
store it in a clean, dry place away from direct sunlight.

Disposal of the device

Do not dispose of the device in your normal domestic waste .
This product is subject to the provisions of the european Directive
2012/19/eU Weee (Waste electrical and electronic equipment) .
Dispose of the device through an approved disposal centre or at your community
waste facility. Observe the currently applicable regulations. In case of doubt,
please contact your waste disposal centre.
TLG 1000 C5
Possible cause
The power cable is not
plugged in.
Mains power socket is not
supplying power.
The batteries are not inserted
as per their polarity.
The inserted batteries are
not suitable for charging.
The temperature monitoring
was initiated.
Solution
Insert the power cable into a mains
power socket.
Check the circuit fuse.
Insert the batteries as per their polarity
(see marking in the charging slot).
Insert exclusively rechargable Ni-Cd
and Ni-MH batteries of the types
AAA/AA/C/D and 9 V Block bat-
teries.
Disconnect the plug from the mains
power socket and allow the device to
cool down.
GB │ CY │ ■
9