Projecting; Projecting The Picture On The Screen - Sony VPL-AW10 Operating Instructions (VPLAW10 and VPLAW15) Operating Instructions Manual

Projecting

This section describes how to operate the projector to view the picture from the equipment
connected to the projector. It also describes how to adjust the quality of the picture to suit
your taste.

Projecting the Picture on the Screen

Example: To view the picture
from the video
equipment connected
to the VIDEO INPUT
connector.
To view the picture from
Video equipment connected to the VIDEO INPUT connector
Video equipment connected to S VIDEO INPUT connector
RGB/component equipment connected to the INPUT A connector
Component equipment connected to Y/P
Equipment connected to the HDMI connector
* Set the "Input-A Signal Sel." setting in the Setup
you set it to "Auto," and cannot display the picture properly, select an appropriate signal
according to the input signal. (1 page 47, 50, 61)
** The color gradation of the dark area or the bright area may become unclear when a signal other
than those from HDMI standard cable is input. Adjust the Brightness and the Contrast in the
Picture menu. (1 page 41)
Tip
When "Auto Input Search" is set to "On" in the Function
signals is automatically displayed by pressing INPUT.
1
Power on both the equipment
and the device connected to the
equipment.
2
Press INPUT repeatedly to
select the input you want to
project on the screen.
Display the indication of the input you
want.
/C /P /C connectors
B B R R
menu according to the signal input. When
menu, the input terminal with effective
Press INPUT to display
Video
S-Video
Input-A*
Component
HDMI**
27