On-Screen Display - Sony VPL-AW10 Operating Instructions (VPLAW10 and VPLAW15) Operating Instructions Manual

Symptom
The picture is too dark.
The picture is not clear.
The picture flickers.

On-screen display

Symptom
On-screen display does not
appear.
The model name does not
disappear from the screen.
Remote control
Symptom
The remote control does
not work.
Others
Symptom
The fan is noisy.
52
Cause and Remedy
c Adjust the contrast or brightness of the Picture
properly. (1 page 41)
c Adjust the focus using the focus ring. (1 page 24)
c Condensation has accumulated on the lens. Leave the projector
for about 2 hours with the power on.
c Activate "APA", then adjust the current input signal.
c Adjust "Phase" for "Adjust Signal" in the Screen
properly. (1 page 45)
Cause and Remedy
c Set "Status" in the Setup
? 1
c Check if the
/ (On/standby) indicator should light in green.
c The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Cause and Remedy
c Batteries could be weak. Replace them with new batteries.
(1 page 11)
c Insert the batteries with the correct polarities. (1 page 11)
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
Cause and Remedy
c Check the setting of "Cooling Setting" in the Setup
(1 page 46)
c Make sure that the room temperature is not too high.
The number of fan rotation increases to maintain the product
reliability of the projector's components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
menu
menu to "On." (1 page 46)
menu
menu.