Sony VPD-MX10 Operating Instructions Manual page 34

Symptom
Color balance is incorrect.
The picture is too dark.
The picture is not clear.
The picture appears too
small on the screen.
The picture flickers.
Sound
Symptom
No sound.
Remote Commander
Symptom
The Remote Commander
does not work.
Others
Symptom
The LAMP/COVER
indicator flashes.
The LAMP/COVER
indicator lights up.
The TEMP/FAN indicator
flashes.
34
GB
Troubleshooting
Cause and Remedy
• Picture has not been adjusted properly.
c Adjust the picture (see page 26).
• Projector is set to wrong color system.
c Set COLOR SYS in the PICTURE CTRL menu to match the
color system being input (see page 27).
• Contrast or brightness has not been adjusted properly.
c Adjust the contrast or brightness in the PICTURE CTRL menu
properly (see page 26).
• Picture is out of focus.
c Adjust the focus (see page 22).
• Condensation has occurred on the lens.
c Leave the projector for about two hours with the power on.
• SHIFT in the INPUT SETTING menu has not been adjusted
properly.
c Adjust SHIFT in the INPUT SETTING menu properly (see
page 28).
• DOT PHASE in the INPUT SETTING menu has not been adjusted
properly.
c Adjust DOT PHASE in the INPUT SETTING menu properly
(see page 27).
Cause and Remedy
• Cable is disconnected or the connections are wrong.
c Check that the proper connections have been made (see page
15).
Cause and Remedy
• The Remote Commander batteries are dead.
c Replace with a new battery (see page 13).
Cause and Remedy
• The lamp cover is detached.
c Attach the cover securely (see page 31).
• The front cover is closed while the power is on.
c Open the front cover.
• The lamp has reached the end of its life.
c Replace the lamp (see page 31).
• The lamp becomes a high temperature.
c Wait for 90 seconds to cool down the lamp and turn on the
power again (see page 23).
• The fan is broken.
c Consult with qualified Sony personnel.